Tumble Dryer Installation/Operation Maintenance Manual

52 M414545

COIN-OPERATED TUMBLER

1. Energize the electrical circuit to the tumbler at the

disconnect switch or the circuit breaker.

2. Open the lint screen panel and check for any

accumulated lint on lint screen. Close panel tightly

against tumbler frame and lock panel securely.

3. Open the loading door and load the cylinder with

laundry. Overloading will result in excessive drying

time, wrinkled laundry, and wear to cylinder

bearings.

4. Set the TEMPERATURE selector at HIGH (190ºF /

87.5ºC), MEDIUM (162ºF / 72ºC), LOW (140ºF /

60ºC), or anywhere between these settings. The type

of fabric being dried will determine the setting.

5. Coin Drop Models

Insert the required number of coins in the coin slot,

turn the knob to the right and release it.

Coin Slide Models

Insert the required number of coins in the coin slide,

push coin slide mechanism in completely and then

release it.

Electronic Control Models

Refer to Electronic Control Supplemental manual

provided with tumbler.

IMPORTANT: If the loading door is opened during

the cycle, the heating system will shut off and the

motor will stop. However, the timer will continue to

run. To restart the cycle, the door must be closed and

the PUSH-TO-START button must be pressed in and

held for approximately three seconds.

6. When the cycle is completed, open door and remove

the laundry.