Tumble Dryer Installation/Operation Maintenance Manual

ManualsBrandsAlliance Laundry Systems ManualsDryer250 C.F.M.

58 M414545

B. Time Dry and No Heat

After fabric selection, press the TIME pad. Refer

to Figure 29.

TIME DRY Pads

Figure 29

A preset drying time, “Td:**” will replace

“A0:00” in the display. This time can be changed

by pressing the MORE or LESS pads. For 1

minute changes, press pad and release. For 5

minute changes, press pad and hold. Maximum

drying time allowed is 60 minutes.

Table 10

AC:** will be displayed when tumbler is in Auto

Cool Down. Typical cool down times for fabric

selections are preset. Refer to Table 9. The cool

down time can only be altered before cycle is

started. To alter cool down time press the COOL

DOWN pad and then press the MORE or LESS

pad (when cool down time is altered, TC:** will

be displayed). For 1 minute changes, press pad

and release. For 5 minute changes, press pad and

hold. Cooling time can be from 1 to 39 minutes.

To return to the Auto Cool Down, press MORE or

LESS pad until AC:** is displayed.

To start the cycle, press START. The total drying

time plus cool down time will display. During the

cycle, remaining time displays.

NO HEAT is a time dry cycle only. When NO

HEAT is pressed, a 20 minute preset time will

display. This can be changed from 1 minute to 60

minutes by pressing the MORE or LESS pads

before pressing START. The COOL DOWN pad

does not work in NO HEAT cycles.

C. Special Cycle Mode

This allows the user to select the number of times

the tumbler will cycle from heat-on to heat-off. To

enter the Special Cycle Mode, press the

SPECIAL CYCLE pad after selecting a cycle.

The display will read “SC:**”. “**” is the number

of times the tumbler will cycle from heat-on to

heat-off. This number can be changed by pressing

the MORE or LESS pads. For increments of 1,

press pad and release. For increments of 5, press

pad and hold for 3 seconds. Range is from 1-99.

Press the START pad and the number shown after

“SC:” is the number of cycles selected, the

number will decrease as each cycle is completed.

The default cool-down cycle for the Special Cycle

Mode is Automatic Cool Down.

NOTE: Since there is only 60 minutes of cycle time,

any cycles not completed within 60 minutes will be

skipped.

NOTE: Unlike the Time Dry mode and Automatic

mode, the regulating temperature in the Special Cycle

Mode has a range of 80°F to 180°F for all heat cycles.

Cycles Preset Time Range

COTTONS 35 Min 1-60 Min.

PERM PRESS 20 Min 1-60 Min.

MIXED 15 Min 1-60 Min.

DELICATES 30 Min 1-60 Min.

NO HEAT 20 Min. 1-60 Min.