Service manual

36 512176
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
38. FRONT PANEL AND PANEL SEAL
a. While supporting the access panel, remove two
screws from bottom edge of access panel. Refer
to Figure 8.
b. Gently lower the access panel to disengage
locators from bottom edge of front panel. Refer
to Figure 17.
c. Remove two screws holding bottom tabs on
front panel to dryer side panels. Refer to
Figure 9. Swing bottom of front panel away
from dryer far enough to disengage hold-down
clips and locators from cabinet top.
d. Disconnect wires from door switch. Refer to
Figure 16.
NOTE: Refer to wiring diagram when rewiring
switch.
e. Remove front panel seal from flange around
inside of door opening. Refer to Figure 17.
NOTE: Be sure seal is properly positioned when
installing on front panel.
39. DOOR SWITCH
a. While supporting the access panel, remove two
screws from bottom edge of access panel. Refer
to Figure 8.
b. Gently lower the access panel to disengage
locators from bottom edge of front panel. Refer
to Figure 17.
c. Remove two screws holding tabs on front panel
to dryer side panels. Refer to Figure 9. Swing
bottom of front panel away from dryer far
enough to disengage hold-down clips and
locators from cabinet top.
d. Disconnect wires from door switch. Refer to
Figure 16.
NOTE: Refer to wiring diagram when rewiring
switch.
e. Depress tabs on switch and push out of front
panel. Refer to Figure 16.
40. DOOR CATCH
a. While supporting the access panel, remove two
screws from bottom edge of access panel. Refer
to Figure 8.
b. Gently lower the access panel to disengage
locators from bottom edge of front panel. Refer
to Figure 17.
c. Remove two screws holding bottom tabs on
front panel to dryer side panels. Refer to
Figure 9. Swing bottom of front panel away
from dryer far enough to disengage hold-down
clips and locators from cabinet top.
d. Disconnect wires from door switch. Refer to
Figure 16.
NOTE: Refer to wiring diagram when rewiring
switch.
e. Depress tabs on top and bottom of catch and
push out of front panel.
Figure 16
Door
Switch
H183SE1A
Tabs