Service manual

M411433 37

Section 5 Service Procedures

To reduce the risk of electric shock, fire, explosion, serious injury or death:

• Disconnect electric power to the tumbler before servicing.

• Close gas shut-off valve to gas tumbler before servicing.

• Close steam valve to steam tumbler before servicing.

• Never start the tumbler with any guards/panels removed.

• Whenever ground wires are removed during servicing, these ground wires must be

reconnected to ensure that the tumbler is properly grounded.

W002

WARNING

38. THERMISTOR

(Electronic Control Models Only)

Refer to Figure 13.

a. Unlock and remove the lint panel.

b. Remove the two screws holding the perforated

cover to the thermistor bracket.

c. Disconnect the wires from the back of the

thermistor.

d. Remove the two screws holding the thermistor

to the bracket.

OM Models: Unthread thermistor from

bracket.

NOTE: Refer to the wiring diagram when

reconnecting the wires to the thermistor.

Figure 13

THERMISTOR

T093SE3C

THERMISTOR

WIRES

SCREW

PERFORATED

COVER

LINT

PANEL

T345P

OM Models