Service manual

M411433 49

Section 5 Service Procedures

To reduce the risk of electric shock, fire, explosion, serious injury or death:

• Disconnect electric power to the tumbler before servicing.

• Close gas shut-off valve to gas tumbler before servicing.

• Close steam valve to steam tumbler before servicing.

• Never start the tumbler with any guards/panels removed.

• Whenever ground wires are removed during servicing, these ground wires must be

reconnected to ensure that the tumbler is properly grounded.

W002

WARNING

58. FRONT PANEL

a. Remove control panel.

b. Unlock, open and remove lint panel. Set aside

to prevent damage.

c. Open loading door, support door and remove

upper hinge bolt holding door to hinge bracket.

Refer to Figure 21.

NOTE: Nylon washer must be in place on lower

hinge pin when reinstalling door.

d. Remove door from bracket.

e. Support front panel and remove screws (and

three speed nuts) holding front panel to tumbler

cabinet. Refer to Figure 24.

NOTE: When removing front panel, lower panel

slightly to make sure door switch rod clears hole in

cabinet.

Figure 24

T032SE1D

FRONT PANEL

ATTACHING SCREWS

(13)

SPEED

NUTS