Service manual

14 505872

Section 3 Troubleshooting

To reduce the risk of electric shock, fire, explosion, serious injury or death:

• Disconnect electric power to the dryer(s) before servicing.

• Close gas shut-off valve to gas dryer(s) before servicing.

• Never start the dryer(s) with any guards/panels removed.

• Whenever ground wires are removed during servicing, these ground wires must be

reconnected to ensure that the dryer is properly grounded.

W001R1

WARNING

14. CLOTHES ARE TOO HOT WHEN REMOVED FROM DRYER

POSSIBLE CAUSE TO CORRECT

Clothes are removed from dryer before cycle has

completed.

• Allow the dryer to complete the cycle through the cool-

down to the OFF position.

Inoperative cycling thermostat. Inoperative

thermostat heat on the DELICATE setting.

• Test cycling thermostat or thermostat heater and replace

if inoperative.

Inoperative accumulator or timer (not allowing

cool-down).

• Test accumulator or timer and replace if inoperative.