Instruction manual

107
F232151
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Collecting Audit Information
This feature allows the owner to retrieve audit
information stored in the washer-extractor by pressing a
sequence of pads on the control. For an explanation of
the audit options available, refer to Table 1.
How to Enter Audit Feature
1. Control must be in Manual Mode to start. Refer
to Entering the Manual Mode.
2. Press the DELICATES (+) or the COLD (-)
keypad until “AUdT” appears. Refer to
Figure 203.
Figure 203
3. Press the START keypad. “CyC” will appear.
If the procedure did not work, the control will return to
the Ready Mode. Refer to Figure 2.
How to Read Audit Data
1. Use the DELICATES (+) or the COLD (-)
keypad to scroll through various options until the
desired option is displayed in the VFD. Refer to
Table 1 for an explanation of the audit options
available. Refer to Figure 204.
Figure 204
2. Once the desired option appears in the VFD,
press the START (enter) keypad once to start the
audit count. At this point, the display will show
the first four-digit segment of the audit value.
Press the START (enter) keypad again to view the
last four digits of the number.
NOTE: The VFD can display up to 4 digits at one
time. All audit counts are separated into two 4-digit
segments. Each time the START (enter) keypad is
pressed in step 2, the VFD will show the next 4-digit
segment in the audit value.
For Example: In the Total Number of Coins #1 option
with “COI1” displayed in the VFD, the audit has
counted 10,009 coins. Pressing the START (enter)
keypad one time will show “_ _ _ 1” to represent ten
thousand. Pressing the START (enter) keypad a second
time will display “0009” meaning nine. The total
equals “00010009” or 10,009.
3. Press the START (enter) keypad again. The
control will go to the next audit option in the
Audit Options List.
4. To select other audit options, repeat steps 1 – 4.
How to Exit Audit Feature
1. Be sure the control shows an audit option, not a
value.
2. While pressing and holding the NORMAL
keypad with one hand, press the PERM PRESS
keypad with the other hand. The control will
return to the Ready Mode. Refer to Figure 2.
C823I
B029R
1 Press this pad (+) to scroll forward or increase a value
2 Press this pad (enter) to choose a selected value or
option
3 Press this pad (-) to scroll back or decrease a value
1
3
2
Audit Options List
#
VFD
Display
Description
1
“CyC”
Total # of machine cycles
2
“COI1”
Total # of coins #1
3
“COI2”
Total # of coins #2
4
“PLSE”
Total # of Start Pulses
5
“CArd”
Smart Card Reader Firmware Version #
Ta bl e 1