Instruction manual

Programming NetMaster
65
F232151
© Copyright, Alliance Laundry Systems LLC DO NOT COPY or TRANSMIT
33. Default Cycle/Temperature
+033
This option allows the owner to set the default cycle
and temperature the machine will enter when in the
Ready Mode. When programming the default cycle,
refer to Table 4 on the following page.
How to Program Default Cycle/Temperature
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the DELICATES (+) or the COLD (-)
keypad until PrOg appears in the VFD. Press
the START (enter) keypad and +001 will
appear in the VFD.
Figure 102
3. Press the DELICATES (+) or the COLD (-)
keypad to scroll through the programmable
options until +033 appears in the VFD. Refer
to Figure 103.
Figure 103
4. When +033 appears in the VFD, press the
START (enter) keypad. A number will appear in
the VFD. This number corresponds to the current
default cycle value.
5. Press the DELICATES (+) or the COLD (-)
keypad to increase or decrease the current number
to the desired number selected from Table 4 on
the following page. Refer to Figure 104.
Figure 104
6. Press the START (enter) keypad when the correct
number appears in the VFD. The next option,
+034, will appear in the VFD.
NOTE: To program +034 (Power Fail Reset),
refer to option 34 in Programming NetMaster in the
Enhanced Programming Guide, available at extra
cost. To program other options, refer to the
appropriate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option,
not a value.
2. While pressing and holding the NORMAL
keypad with one hand, press the PERM PRESS
keypad with the other hand. The control will
revert back to the Ready Mode. Refer to
Figure 2.
C762I
C779I
B029R
1 Press this pad (+) to scroll forward or increase a value
2 Press this pad (enter) to choose a selected value or
option
3 Press this pad (-) to scroll back or decrease a value
neednew#2
1
32