Instruction manual

Programming NetMaster
F232151
76
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
45. Normal Rinse #1 Fill/Tumble
Time “+045”
This option allows the owner to set the amount of rinse
#1 fill/tumble time for the Normal cycle.
How to Program Normal Rinse #1
Fill/Tumble Time
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the DELICATES (+) or the COLD (-)
keypad until “PrOg” appears in the VFD. Press
the START (enter) keypad and “+001” will
appear in the VFD.
Figure 132
3. Press the DELICATES (+) or the COLD (-)
keypad to scroll through the programmable
options until “+045” appears in the VFD. Refer
to Figure 133.
Figure 133
4. When “+045” appears in the VFD, press the
START (enter) keypad. The current number of
minutes set for the Normal Rinse #1 Fill/Tumble
Time will appear in the VFD.
5. Press the DELICATES (+) or the COLD (-)
keypad to increase or decrease the current
number of minutes displayed in the VFD to the
desired number of minutes. Refer to Figure 134.
NOTE: The Normal Rinse #1 Fill/Tumble Time can
be set from zero (0) to 15 minutes.
Figure 134
6. Press the START (enter) keypad when the correct
number of minutes appears in the VFD. The next
option, “+046”, will appear in the VFD.
NOTE: To program “+046” (Normal Rinse Extra
Fill/Tumble Time), refer to option 46 in
Programming NetMaster in the Enhanced
Programming Guide, available at extra cost. To
program other options, refer to the appropriate
section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option,
not a value.
2. While pressing and holding the NORMAL
keypad with one hand, press the PERM PRESS
keypad with the other hand. The control will
revert back to the Ready Mode. Refer to
Figure 2.
C762I
C806I
B029R
1 Press this pad (+) to scroll forward or increase a value
2 Press this pad (enter) to choose a selected value or
option
3 Press this pad (-) to scroll back or decrease a value
neednew#2
1
32