Service manual

800170 155
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer/dryer before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start the washer/dryer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer/dryer is properly grounded.
W014R1
WARNING
c. Removal of 510068 Card Reader:
(1) Unlock control panel. Refer to Figure 13,
Step 1.
(2) Pull top of control panel away from control
cabinet far enough to allow lifting control
panel up and off the rail support of the
control cabinet front. Refer to Figure 13,
Step 2.
(3) Remove control panel away from control
cabinet as far as wires permit. Refer to
Figure 13, Step 3.
(4) Disconnect card reader harness at
disconnect block.
(5) Use a 3/8 inch square drive socket, with
number 310P4 1/4 inch Ratchet Extension
Tool, to remove screws or nuts holding
card reader to control cabinet front and
carefully remove card reader out through
top of control cabinet. Refer to Figure 18
or 19.
NOTE: A 3/8 inch square drive socket, size 7/16
inch, fits over end of the 310P4 Extension Tool. A
1/4 inch ratchet fits in the other end. Refer to
Figure 19.
d. Installation of 510068 Card Reader:
(1) Carefully place card reader into opening in
control cabinet front.
(2) Using a 3/8 inch square drive 7/16 inch
socket with number 310P4 1/4 inch
Ratchet Extension Tool, secure card reader
to control cabinet front with screws or nuts
previously removed. Refer to Figure 18 or
19. Then tighten screws or nuts firmly.
(3) Reconnect card reader harness.
(4) Reinstall control panel in control cabinet
and lock control panel.
Figure 18
DRY978S
Control
Cabinet
Front
Card
Reader
Control Cabinet Front to Top Flange of
Front Panel Attaching Screws
Models Equipped With
510068 Card Reader