Installation Guide

18.00
457.20
PULL ASSY
SURFACE MOUNTED
MOUNTING SCREW (2X)
Step 1:
Determine your desired location for installation and make a mark for the location.Make 2 marks where mounting screws will
be placed as shown below. Drill hole at each of the marks.
Drill holes for the desired location.
Pull Mounting
Step 2:
Mount Pull to desired location through screws provided.
AT-30-RP
INSTALLATION INSTRUCTIONS
No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.