Installation Guide

MOUNTING PLATE
PATTERN
DRILLED HOLES
SCREW
MOUNTING PLATE
DRILLED HOLE
ANCHOR
SET SCREW
BACK PLATE
MOUNTING PLATE
BACKPLATE
SET SCREW
No portion of this document or any artwork contained herein should be reproduced in anyway without the express written consent of ALLIED BRASS INC.
DT-20
INSTALLATION INSTRUCTIONS
Step 1: Drill holes in Wall for screw anchors and attach Mounting Plate to Wall
Step 2: Attach Bracket to Mounting Plate
Place bracket on mounting plate and secure by tightening set screw as shown below.
Determine your desired location for installation and make a mark for the location of the mounting plate. Remove mounting
plate from backplate by loosening set screw in backplate as pictured below. Place center hole of mounting plate over mark
made above. Make 2 marks where mounting screws will be placed as shown below. Drill hole at each of the marks. (You may
substitute other style mounting anchors or screws if desired). Place anchors into the holes made. Place mounting plate over
holes and secure to mounting surface using screws as shown below.