Installation Guide

0.43
10.92
0.56
14.15
PULL ASSY
SURFACE MOUNTED
MOUNTING SCREW
Step 1:
Determine your desired location for installation and make a mark for the location.Make 1 mark where mounting screws will be
placed as shown below. Drill hole at the mark.
Drill holes for the desired location.
Pull Mounting
Step 2:
Mount Pull to desired location through screws provided.
F-10
INSTALLATION INSTRUCTIONS
No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.