Installation Guide

13.50

MOUNTING SCREW

LUG

Back Plate

Step 1:

Measure and mark for two holes in the wall based on the center to center of the Towel Bar.

Drill 1/2" holes into marks for Toggle Wings and screws.

Drill Holes into the Wall

Mounting of Screws

Screws are inserted through the mounting lug so that it protrudes through other side

of backplate.

Step 2:

FR-1G-16

INSTALLATION INSTRUCTIONS

No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.

PAGE 1
FR-1G-16 INSTALLATION INSTRUCTIONS Step 1: Drill Holes into the Wall Measure and mark for two holes in the wall based on the center to center of the Towel Bar. Drill 1/2" holes into marks for Toggle Wings and screws. 13.50 Step 2: Mounting of Screws Screws are inserted through the mounting lug so that it protrudes through other side of backplate.
PAGE 2
Step 3: Wing Nut Installation Wing nut is attached to screw and pushed into wall. Make sure the head of the screw fits inside the countersink of the mounting lug. Make same process on mounting the other Back Plate. BACK PLATE WING NUT INITIAL POSITION -SQUEEZED OFF TO FIT DRILLED HOLE IN WALL MOUNTING LUG WING NUT (INSTALLED) MOUNTING SCREW WALL Step 4: Tower Bar Installation Backplates are tightened against wall and Towel Bar are attached to mounting lug with the use of set screws.