Installation Guide

WING NUT INITIAL POSITION

-SQUEEZED OFF TO FIT DRILLED HOLE

IN WALL

WING NUT (INSTALLED)

WALL

MOUNTING SCREW

BACK PLATE

MOUNTING LUG

WALL

Towel Bar

Set Screw

Step 3:

Wing nut is attached to screw and pushed into wall. Make sure the head of the screw fits

inside the countersink of the mounting lug. Make same process on mounting the other

Back Plate.

Wing Nut Installation

Tower Bar Installation

Backplates are tightened against wall and Towel Bar are attached to mounting lug with the

use of set screws.

Step 4:

No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.