Installation Guide

ANCHOR
THREAD
INSERT
DRILLED HOLE
SCREW
CARD-58 CAP
6.35
Step 1:
Determine your desired location for installation and make a mark for the location . Make 2 marks where mounting screws will
be placed as shown below. Make sure shelf is level when marking for location of installation.Drill hole at each end of the
marks.
Drill holes in Wall for screw anchors
Attach Shelf to mounting Surface.
Step 2:
FT-6
INSTALLATION INSTRUCTIONS
No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.