Installation Guide

PULL ASSY

MOUNTING

SCREW

Step 1:

Determine your desired location for installation and make a mark for the location.Make mark where mounting screw will be

placed as shown below. Drill hole at the mark.

Drill holes for the desired location.

Pull Mounting

Step 2:

Place Pull to the desired location and screw from behind.

SURFACE MOUNTED

G-1

INSTALLATION INSTRUCTIONS

No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.

PAGE 1
G-1 INSTALLATION INSTRUCTIONS Step 1: Drill holes for the desired location. Determine your desired location for installation and make a mark for the location.Make mark where mounting screw will be placed as shown below. Drill hole at the mark. Step 2: Pull Mounting Place Pull to the desired location and screw from behind. SURFACE MOUNTED MOUNTING SCREW PULL ASSY No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.