Installation Guide

1/8 PIPE NIPPLE

BACK PLATE

MOUNTING LUG

1/8 HEX NUT

BACK PLATE

MOUNTING SCREW

Step 1:

The backplates have 3 mounting lugs attached to them with the use of a short 1/8 Pipe

Nipple (hollow in center) .

Installing Mounting Lug to Backplate

Mounting of Screws

Screws are inserted through the mounting lug so that it protrudes through other side

of backplate.

Step 2:

HTL-Tower Shelf

INSTALLATION INSTRUCTIONS

No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.

PAGE 1
HTL-Tower Shelf INSTALLATION INSTRUCTIONS Step 1: Installing Mounting Lug to Backplate The backplates have 3 mounting lugs attached to them with the use of a short 1/8 Pipe Nipple (hollow in center) . 1/8 HEX NUT MOUNTING LUG 1/8 PIPE NIPPLE BACK PLATE Step 2: Mounting of Screws Screws are inserted through the mounting lug so that it protrudes through other side of backplate.
PAGE 2
Step 3: Wing Nut Installation Wing nut is attached to screw and pushed into wall. WING NUT (INSTALLED) MOUNTING LUG BACK PLATE WING NUT INITIAL POSITION -SQUEEZED OFF TO FIT DRILLED HOLE IN WALL MOUNTING SCREW WALL SECTION VIEW OF THE INSTALLATION Step 4: Arms Installation Backplates are tightened against wall and then three arms are attached to mounting lug with use of set screw.