Installation Guide

DRILLED HOLE BRACKET
DRILLED HOLE
ANCHOR
SCREW
BRACKET
GLCR-8
No portion of this document or any artwork contained herein should be reproduced in anyway without the express written consent of ALLIED BRASS INC.
PR-6
INSTALLATION INSTRUCTIONS
Step 1: Drill holes in Wall for screw anchors
Step 2: Attach Shelf to Mounting Surface
Place anchors to the holes made in step 1. Fasten screws to anchors and leave gap equal to thicknes of the bracket. Slide
brackets into screws as shown below.
Determine your desired location for installation and make a mark for the location of the mounting bracket. Make 2 marks
where mounting screws will be placed as shown below. Make sure shelf is level when marking location for installation. Drill
hole at each of the marks.