Installation Guide

LEFT SIDE ASSEMBLY

RIGHT SIDE ASSEMBLY

LEFT SIDE ASSEMBLY

RIGHT SIDE

ASSEMBLY

Tube

Step 1:

Place the Left and Right side assemblies upright on the floor with short assembly nipples pointing towards each other.

SIDE ASSEMBLY

Step 2:

TUBE ASSEMBLY

Slip each of the 6 long shelf tubes over short Left side assembly nipples, then slide the Right side assembly inward, inserting

the assembly nipples into the other ends of the Long tubes.

PR-HTL-5

ASSEMBLY INSTRUCTIONS

No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.

PAGE 1
PR-HTL-5 ASSEMBLY INSTRUCTIONS Step 1: SIDE ASSEMBLY Place the Left and Right side assemblies upright on the floor with short assembly nipples pointing towards each other. LEFT SIDE ASSEMBLY RIGHT SIDE ASSEMBLY Step 2: TUBE ASSEMBLY Slip each of the 6 long shelf tubes over short Left side assembly nipples, then slide the Right side assembly inward, inserting the assembly nipples into the other ends of the Long tubes.
PAGE 2
PR-HTL-5 INSTALLATION INSTRUCTIONS Step 1: Drill holes in Wall for screw anchors and attach Mounting Plate to Wall Determine your desired location for installation and make a mark for the location of the mounting plate. Remove mounting plate from backplate by loosening set screw in backplate as pictured below. Place center hole of mounting plate over mark made above. Measure and mark two holes on the wall for each mounting plate based on the center to center locations of the 4 back plate mounting plate .
PAGE 3
PR-HTL-5 INSTALLATION INSTRUCTIONS Step 2: Attach Bracket to Mounting Plate. Place bracket on mounting plate and secure by tightening set screw as shown below. L PERSPECTIVE BACK PLATE MOUNTING PLATE SET SCREW DETAIL L No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.