Installation Guide

ROD 2

ROD 1

CONNECTOR

BRACKET

Step 1:

Assemble two sections of rod together with connector.

ROD ASSEMBLY

BRACKET ASSEMBLY

Step 2:

Measure opening of shower or tub enclosure and cut equal amount off each end of rod to match size of opening. Install rod

into brackets (sold separately) as per bracket installation instructions.

SR-72

INSTALLATION INSTRUCTIONS

No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.

PAGE 1
SR-72 INSTALLATION INSTRUCTIONS Step 1: ROD ASSEMBLY Assemble two sections of rod together with connector. CONNECTOR ROD 1 ROD 2 Step 2: BRACKET ASSEMBLY Measure opening of shower or tub enclosure and cut equal amount off each end of rod to match size of opening. Install rod into brackets (sold separately) as per bracket installation instructions. BRACKET No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.