Installation Guide

3.00
76.20
PULL ASSY
MOUNTING
SCREW (2X)
Step 1:
Determine your desired location for installation and make a mark for the location.Make 2 marks where mounting screws will
be placed as shown below. Drill hole at each of the marks.
Drill holes for the desired location.
Pull Mounting
Step 2:
Placed Pull to the desired location and screw from behind.
SURFACE MOUNTED
W-3-3
INSTALLATION INSTRUCTIONS
No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.