Installation Guide

DRILLED HOLE
SET SCREW
SCREW
ANCHOR
MOUNTING PLATE
Step 1:
Determine your desired location for installation and make a mark for the location of the mounting plate. Remove mounting
plate from backplate by loosening set screw in backplate as pictured below. Place center hole of mounting plate over mark
made above. Measure and mark two holes on the wall for each mounting plate based on the center to center locations of the
4 back plate mounting plate . Drill hole at each of the marks. (You maysubstitute other style mounting anchors or screws if
desired). Place anchors into the holes made. Place mounting plate overholes and secure to mounting surface using screws
as shown below.
Drill holes in Wall for screw anchors and attach Mounting Plate to Wall
PERSPECTIVE
DRILLED HOLE
BACK PLATE
HTL-5
INSTALLATION INSTRUCTIONS
No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.