User Guide

AT-S94 Version 3.0.0.41 Software Release Notes
PN 613-001480 Rev A 8 Allied Telesis, Inc.
5. Select number one by pressing the ‘1’ key.
The switch will respond with the following message:
Begin the transmission of a previous version.
Downloading code using XMODEM.
You may proceed with the xmodem transfer.
6. When the download is complete, reboot the switch.
7. Install the latest boot loader (s94bv10107.rfb) using the copy command. You may use the
xmodem or TFTP options as described in the AT-8000S CLI Reference Guide.
8. Install the Version 3.0.0.41 software by the following steps 6 - 8 in “Upgrade Procedure from
Version 1.0.0.25” on page 12.
History of Resolved Issues
Version 3.0.0.40
 PC is beginning re-authentication after 30 seconds and this fails although still have
connectivity. (CQ 117489 ATI 188)
 NAP is not working. (CQ 117116 ATI 199)
 Operation MAU in LLDP_MAD MAC/PHY TLV is 0 instead of 16. (CQ 117561 ATI 208)
 Does not learn more than 30 LLDP-MED end points (CQ 121240 ATI 235)
 Problem with IGMP Snooping on AT-8000S/48 stack - fatal error. (CQ 121102 ATI 230)
 GVRP + LACP - GVRP does not recover after a fail. (CQ 120476 ATI 234)
 Problem with IGMP Snooping on AT-8000S/48 stack - fatal error operation - SW2M:
ABORT DATA exception. (CQ 122604)
 Stack issue - broadcast blocked when using “bridge multicast unregistered filtering”. (CQ
122469 ATI 244, ATI 251)
Version 3.0.0.38
 udp-mib - definition for udpHCGroup has been commented out. (CQ ID 119274)
 The rlpoe.mib has an incorrect module name. (CQ 118708 ATI 221)
 DHCP snooping doesn't work on guest VLAN. (CQ 117217 ATI 204)
 The command “default-vlan vlan” is not available on 8000S. (CQ 118706 ATI 219)
 Cannot apply IP ACL because of lack of HW resources. (CQ 118117 ATI 214)
 There is no support for MIB counters ifInErrors & ifOutErrors.(CQ 117172 ATI 202)
Version 3.0.0.35
 Multicast - When several multicast groups are registered on a port, all will be deleted
when an IGMP Leave report for just 1 of the groups is received on the port (CQ
ID114173)
 EWS - User can not add a VLAN via GUI interface if the VLAN ID starts with 5,6,7,8,9
(CQ ID 115354)
 SNMP - Added support for SNMP trap when master stack unit is down (CQ ID 117040)