Manualshelf

User's Manual

ManualsBrandsAllied Telesis ManualsNetwork HardwareAllied Telesis Allied Telesis Network Hardware AT-PC232/POE
51525354555657585960
AT-LX44000 Multi-Protocol WDM Transport System Installation Guide
59
2. Place the ferrule tip on the exposed cleaning surface and rub the
ferrule in a downward direction, as shown in Figure 21.
Figure 21. Rubbing the Ferrule Tip on the Cleaning Surface
Rub the ferrule tip on the cleaning surface in one direction only.
3. When you reach the end of the cleaning surface, pick up the ferrule tip,
rotate and place it at the top and rub downwards at least 2 times.
Failing to pick up the ferrule tip when you reach the bottom of the
cleaning surface can result in static electricity that can damage the
fiber optic cable.
4. If desired, repeat steps 3 and 4.
5. If a fiber inspection scope is available, use the scope to inspect the
ferrule end face to make sure that it is clean.
6. Reconnect the cable to the port or protect the ferrule tip with a dust
cap.
Always keep a dust cap on a fiber optic cable when it is not in use.
Do not touch the end face of the ferrule in the connector.
102