User's Manual

Chapter 7: Maintenance Menu
162
Switching the Primary and Secondary Management Software Images
The access point maintains primary and secondary images of the
management software in flash memory. The primary image is used during
normal operations. If the access point encounters a problem with the
primary image when it is powered on or reset, it loads the secondary
image instead and enters an event message in the log file to signal the
problem with the primary image.
If you reset or power cycle the access point, the device again tries to load
the primary again, and again switches to the secondary image if it cannot
load the primary image.
If this problem keeps occurring, you can instruct the access point to switch
the images, so that the secondary image becomes the primary image, and
the primary image becomes the secondary image.
Caution
This procedure is disruptive to the wireless network because the
access point does not forward traffic for approximately two minutes
while it switches the images. To minimize the disruption to the
wireless clients, you should perform this procedure during non-
business hours.
To switch the primary and secondary images, perform the following
procedure:
1. From the Maintenance menu, select Upgrade.
The management software displays the “Manage firmware” window,
shown in Figure 53.
Figure 53. Manage Firmware Window