Installation guide

Page 8
Allied Telesis AT-8000S Switch
Switch Installation Guide
AT-8000S/16 Front Panel
The following figure illustrates the AT-8000S/16 front panel.
Figure 1: AT-8000S/16 Front Panel
The AT-8000S/16 front panel is configured as follows:
• 16 10/100Mbps ports — RJ-45 ports designated as 10/100Base-T. The RJ-45 ports are designated as ports
Ports1-16.
• 1 1000Base-T Copper ports — Copper RJ-45 Gigabit port designated on the device as port 17. The port is a
Combo port linked to the SFP port.
• 1 SFP Port — There is one SFP port, which contains a 1000Base-X (fiber) connection designated on the
device as port 17. This is a Combo port linked to the 1000Base-T Copper port.
• DB-9 Console port — An asynchronous serial console port supporting the RS-232 electrical specification.
The port is used to connect the device to the console managing the device.
• Reset Button — Button to reset the device.
• Mode Button — Selects the port LED indications.
AT-8000S/16 Back Panel
The following figure illustrates the AT-8000S/16 back panel.
Figure 2: AT-8000S/16 Back Panel
The AT-8000S/16 back panel is configured as follows:
• Power Connector — AC power supply interface.