Installation guide

19
Chapter 2
AT-Setup for Windows 98, 2000,
Me, or XP
This chapter contains the instructions for:
❑ Running AT-Setup on page 22
❑ Running AT-Setup to Complete Driver Installation on page 27
Before running AT-Setup, be sure to read AT-Setup Guidelines on page
21.
Overview
Allied Telesyn has created a special program called AT-Setup to simplify
the installation of your network adapter card and driver. This program
automatically installs, updates, or corrects the adapter driver on your
computer.
You can run AT-Setup either before or after you install the adapter card.
Running AT-Setup before installing the adapter card will pre-load the
appropriate driver.
If you install an adapter card in your system before running AT-Setup,
your operating system may attempt to install an adapter driver
automatically. This will depend on your Windows operating system and
which Allied Telesyn adapter card you are installing. Microsoft’s New
Hardware Installation Wizard will prompt you to install the appropriate
driver for the adapter card. You can either instruct the installation wizard
to the proper location or cancel and perform AT-Setup without
removing the adapter card.
You can also use AT-Setup to correct problems during installation. If an
error message occurs, simply run AT-Setup again. This will allow
AT-Setup to scan your operating system and fix any known issues.