User`s guide

Installing the Hardware
30
Installing a Network Adapter Card
The following instructions apply to installing an AT-2711 series adapter
card in most systems. Refer to the manuals that were supplied with your
system for details about performing these tasks on your particular system.
To install the network adapter card, perform the following procedure:
1. Review the “Pre-Installation Checklist” on page 27 and “Reviewing
Safety Precautions” on page 25.
Before installing the adapter card, ensure the system power is OFF
and unplugged from the power outlet, and that proper electrical
grounding procedures have been followed.
Warning
High voltage inside the system presents a safety hazard. Make sure
the power is off before removing the cover.
2. Remove the system cover and select any empty PCIe slot. See
Figure 6.
If you do not know how to identify a PCIe slot, refer to your system
documentation.
Figure 6. Removing the PC Cover