Manual

Chapter 10: Troubleshooting
114
Figure 23. Command Window with pconfig/all displayed
4. Type ping <IP address> from the command line, then press Enter.
The network connectivity information is displayed, as shown in
Figure 24.
Figure 24. Command Window with ping displayed
NetWare To ping an IP host on the network to verify a connection has been
established, perform the following procedure.
1. From the command line, type ping <IP address>, then press Enter.
This command displays the packet send/receive status.
Linux To verify that the Ethernet interface is up and running, run ifconfig to
check the status of the Ethernet interface. In addition, you can also use
the netstat -i command to check the statistics on the Ethernet
interface. Consult the manual pages for more information about the
ifconfig and netstat commands.