Layer 2 Fast Ethernet Switch Installation Guide

AT-8000/8POE Layer 2 Fast Ethernet Switch Installation Guide
41
Installing an Optional SFP Transceiver
The AT-8000/8POE Fast Ethernet Switch has one SFP uplink port.
To install an SFP transceiver, perform the following procedure:
Note
The transceiver can be hot-swapped; you do not need to power off
the switch to install a transceiver. However, always remove the
cables before removing the transceiver.
Note
You must install the transceiver before you connect cables to it.
1. Remove the transceiver from its shipping container and store the
packaging material in a safe location.
Warning
An SFP transceiver can be damaged by static electricity. Be sure to
observe all standard electrostatic discharge (ESD) precautions,
such as wearing an antistatic wrist strap, to avoid damaging the
transceiver.
2. Remove the dust plug from the SFP slot, as shown in Figure 9.
Figure 9. Removing the Dust Plug from the SFP Slot
3. Locate the label on the transceiver and turn it so that the label is on top
and the alignment groove is on the bottom.
99R
13
5
7
2
4
6
8
TERMINAL PORT
10/100/1000
Ba
se-T
SFP
UPLINK PO
R
T
RS-232
824