User`s guide

AT-S39 User’s Guide

203

Enabling and Disabling Port Access Control

To globally enable or disable Port Access Control, perform the following

procedure:

Note

Enabling or disabling Port Access Control can only be performed in

a local management session.

Note

Before activating this feature, you must have the RADIUS EAP

specified and enabled as the authenication method. This is

discussed in Configuring an Authentication Method on page 195.

1. From the Main Menu, type 1 to select Port Menu (shown in Figure 54).

2. Type 6 to select Port Access Control (shown in Figure 54).

Figure 54 Port Access Control Menu

3. Type 1 to select Port Access Control. The following prompt is

displayed:

Port Access Control (E-Enable, D-Disable) :

4. Type E to enable port access control, or D to disable port access

control. Press Return.

5. Type S to select Save Configuration Changes.

Allied Telesyn Ethernet Switch AT-8024

Port Access Control

1 - Port Access Control .............. Enabled

2 - Authentication Method ............ RADIUS EAP

3 - Configure Port Access Parameters

4 - Display Port Access Parameters

5 - Display Port Access Status

S - Save Configuration changes

R - Return to Previous Menu

Enter your selection?