Specifications

Hardware Reference 21
C613-03092-00 REV D
FAIL: BBR test. Error address =
location
BBR size/location test failed at the given location. The test
at this location failed, indicating the end of memory, but a
valid location was discovered in the 255 long words
following this location. The BBR system must be replaced.
Contact your authorised distributor or reseller.
FAIL: BBR test, only 16k bytes
found
The BBR size/location test completed, but only the
displayed amount of memory was found. This amount is
less than the minimum required to run the switch
software.
INFO: Self tests complete Startup tests have finished.
INFO: Downloading switch
software
The process of downloading the switch software and
vector table from ROM is about to begin.
ERROR: Code load retried
FAIL: Code load failed
Loading code from ROM to RAM failed. The load is retried
a number of times, and the error message is displayed
each time it fails. The fail message is displayed if the switch
reaches the maximum number of attempts.
Force EPROM download (Y) ? Prompt that lets you override the standard startup
sequence, typically when troubleshooting.
INFO: Initial download
succeeded
Startup tests and download are complete, and the switch
software is about to be started.The release is now
decompressed. This may take a few seconds.
INFO: Downloading
compressed release. This may
take up to 1 minute...
INFO: Loading software into
memory. This may take up to 1
minute...
The main switch software is decompressed before being
loaded into RAM.
INFO: Executing configuration
script <script-name>
Configuration commands in the given script file begin
executing if selected by the user. If the script has an error,
appropriate error messages are displayed.
INFO: Switch startup complete The startup process is complete and the switch is ready. If
devices connected to it are sending traffic, then the switch
begins switching operations.
Message Description (cont)