Specifications
Table Of Contents
- AT-8900 Series Hardware Reference
- Contents
- Models Covered By This Reference
- Why You Should Read This Reference
- Where To Find More Information
- Hardware Description
- Online Documentation
- AT-TFTP Server
- Using Windows Terminal and Windows Hyperterminal
- Switch Start-up
- RS-232 Terminal Port (ASYN0)
- Useful Cables
- Test Facility
- Power Supply Units (PSUs)
- Port, Connector, and Cable Combinations
- Troubleshooting
- Expansion Options
- Restricted Procedures
- Contacting Us
14 AT-8900 Series Switch
C613-03075-00 REV A
FAIL: BBR test. Error address = 12345678.
The BBR size/location test failed at the given location. The test at this
location failed, indicating the end of memory, but a valid location was
discovered in the 255 long words following this location. The BBR
system will need to be replaced. Contact your Authorised Allied
Telesyn distributor or reseller.
FAIL: BBR test, only 16k bytes found.
The BBR size/location test completed, but only the displayed amount
of memory was found. This amount is less than the minimum required
to run the switch software.
INFO: Self tests complete.
The start-up tests have finished.
INFO: Downloading switch software.
The process of downloading the switch software and vector table from
ROM is about to begin.
ERROR: Code load retried.
FAIL: Code load failed.
The load of the code from ROM to RAM failed. The load is retried a
number of times. Each time a failure occurs, the ERROR message is
displayed. If the maximum number of attempts is reached, the FAIL
message is displayed.
INFO: Initial download succeeded.
The start-up tests and download are complete, and the switch software
is about to be started. If the default install is a compressed release, the
release will now be decompressed. This may take a few seconds.
INFO: Downloading compressed release. This may take up to 1
minute...
INFO: Loading software into memory. This may take up to 1
minute...
The main switch software is about to be loaded into RAM. If the release
is a compressed release, the release will be decompressed.
INFO: Executing configuration script <script-name>
The configuration commands stored in <script-name> are being
executed. If an error is found in the script, one or more ERROR
messages will be displayed.
INFO: Switch startup complete.
The start-up process is complete and the switch will now perform basic
switching operations. Further configuration will be necessary if you wish to
access the switch’s full layer 3 switching capabilities. See the AT-8900 Series
Software Reference for detailed information on configuring the switch.