Installation guide

AT-ANC10S/2 and AT-ANC10S/4 Adapters Installation and User’s Guide
101
Linux
To verify that the bnx2x.o (or bnx2x.ko) driver is loaded properly, enter:
lsmod
If the driver is loaded, a line similar to one Table 9 is displayed, where size
indicates the size of the driver in bytes, and number is the number of
adapters configured.
Running a Cable
Length Test
For a Windows operating systems, see “Analyzing Cables” in the
Broadcom Advanced Control Suite 4 User Guide for information on
running a cable length test.
Testing Network
Connectivity
This section describes how to test network connectivity for the Windows
and Linux platforms.
Note
When using forced link speeds, verify that both the adapter and the
switch are forced to the same speed.
Windows
In the Windows platforms, use the ping command to test network
connectivity. If the new adapter is the only adapter in the system, you may
test it by having it ping another device on the network. But if the new
adapter is in a system that contains more than one adapter, you instead
should test it by pinging it from another device on your network.
Note
Network connectivity can also be tested using the “Testing the
Network” feature in the Broadcom Advanced Control Suite 4 User
Guide.
To determine if the network connection is working, do the following:
1. Click Start, and then click Run.
2. Type cmd in the Open box, and then click OK.
Table 9. Linux Module Size
Module Size Used by
BCM5709 size number