Installation guide

SwitchBlade x8112 Chassis Switch Installation Guide
131
Figure 82. Securing the Power Cord for the AT-SBxPWRSYS1 Power
Supply to an Anchor
4. Connect the power cord to an appropriate AC power source to power
on the power supply.
5. If the chassis has two AT-SBxPWRSYS1 System Power Supplies,
repeat steps 1 to 4 to power on the second power supply.
After powering on the AT-SBxPWRSYS1 System Power Supplies, do one
of the follow:
 If the chassis has AT-SBxPWRPOE1 PoE Power Supplies,
perform the procedure in “Applying A/C Power to the AT-
SBxPWRPOE1 Power Supplies” on page 132.
 Otherwise, go to “Monitoring the Initialization Process” on
page 135.