Installation guide

SwitchBlade x8112 Chassis Switch Installation Guide
133
3. Use the twist tie that comes with the power supply to secure the cord to
an anchor on the chassis, as shown in Figure 84.
Figure 84. Securing the Power Cord for the AT-SBxPWRPOE1 Power
Supply to an Anchor
4. Connect the power cord to an appropriate AC power source to power
on the power supply.
5. If the chassis has two AT-SBxPWRPOE1 Power Supplies, repeat this
procedure to power on the second power supply.
Figure 85 on page 134 is an illustration of the power cords for a
chassis with four power supplies.