Installation guide

14
5. Attach the data cables to the switching hub
ports. Do not use a cross-over cable to connect
workstations or servers to ports 1 through 5.
Do not use a cross-over cable to connect
another switch or hub to the Uplink port.
Note
You can use either port 5 or the Uplink
port on an AT-FH705E Switching Hub,
but you cannot use both simultaneously.
6. Go to the procedure “Verifying and
Troubleshooting the Installation” on page 16.
Installing the Unit on a Wall
For wall-mount installation, you can position
the device vertically or horizontally on the wall
using the keyhole cutouts in the bottom of the
hub chassis.
1. If previously attached, remove the rubber feet
and all cables and the DC power cord from the
device.
2. Select a wall location for the device.