Installation guide

AT-FH705E Installation Guide
15
Note
For wall-mount installation, you must
supply the two screws and plastic
anchors or other material necessary to
physically mount the device on the wall.
3. Install two plastic anchors and two pan-head
screws into the wall, separated by 5
centimeters (approximately 2 inches).
4. Position the device onto the wall screws.
5. Plug the power adapter into the power
receptacle, then plug the DC power cord into
the DC connector on the front panel of the
switching hub.
Warning
The power cord is used as a
disconnection device. To de-energize
equipment, disconnect the power cord.
5
6. Connect the data cables to the ports on the
switching hub.