Installation guide

AT-FH705E Installation Guide
17
AT-FH705E Switching Hub.
❑ Check to be sure that the power outlet has
power by connecting another device to it.
❑ Try replacing the power adapter with
another power adapter.
2. Check the Link/Act LED for each port. The
LED should be lit steady or flashing. If a
Link/Act LED is OFF, check the following:
❑ Check to be sure that the node connected
to the port on the AT-FH705E is powered
ON. If the node is OFF, power the unit
ON.
❑ Check to be sure that the distance
between the hub and the connected
network device is no greater than 100
meters (328 feet).
❑ Check to be sure that you are using
Category 5 cable.
❑ Check to be sure that the cable has not
been cut or damaged.