User Guide

ManualsBrandsAllied Telesis ManualsOtherAT-FS750-24POE

PN 613-001565 Rev A 1

AT-S105 Version 1.1.0 Management

Software Release Notes

AT-FS750/24POE and AT-FS750/48

Fast Ethernet WebSmart Switches

Please read this document before you begin to use the management software.

NOTE

This document is intended for GREEN AT-FS750/24POE and AT-FS750/48 switches

that display the following

GREEN ECO-friendly symbol on the left side of the front panel:

If you do not find this

GREEN ECO-friendly symbol on the front panel of your switch, please

go to the Product Legacy web page at http://www.alliedtelesis.com/support/legacy for the

latest product documentation and firmware for your product. On this web page,

select “Switches” in the Product Category field and select either “AT-FS750/24POE”

or “AT-FS750/48“from the Product Name field.

Supported Platforms

The AT-S105 Version 1.1.0 is supported on the AT-FS750/24POE and AT-FS750/48 Fast

Ethernet WebSmart switches.

Product Documentation

For the AT-FS750/24POE and AT-FS750/48 documentation, refer to the following guides:

 AT-FS750/24POE Fast Ethernet WebSmart Switch Installation Guide

 AT-FS750/48 Fast Ethernet WebSmart Switch Installation Guide

 AT-S105 Management Software User’s Guide

These documents are available in portable document format (PDF) on our web site. For

instructions to view or download these documents, go to “Where to Find Management Software

Updates and Product Information” on page 4 for further information.

Summary of content (4 pages)

PAGE 1
AT-S105 Version 1.1.0 Management Software Release Notes AT-FS750/24POE and AT-FS750/48 Fast Ethernet WebSmart Switches Please read this document before you begin to use the management software. NOTE This document is intended for GREEN AT-FS750/24POE and AT-FS750/48 switches that display the following GREEN ECO-friendly symbol on the left side of the front panel: If you do not find this GREEN ECO-friendly symbol on the front panel of your switch, please go to the Product Legacy web page at http://www.
PAGE 2
AT-S105 Version 1.1.0 Software Release Notes What’s New in Version 1.1.0 New Features The following features have been added to the AT-S105 Version 1.1.0 software: ACL - Access Control Lists are now supported by port, Mac Address or IP address. LACP Standby Mode - No additional setting is required for LACP Standby mode. The standby feature only works when you select more port members than the trunk limitation.
PAGE 3
AT-S105 Version 1.1.0 Software Release Notes On the AT-FS750/48 switch, Flow Control is functional between ports 1 - 24 or between ports 25 - 50. It is not functional between a port in the first group and another port in the second group. Known Issues The following issues were found in this release: Flow Control does not operate properly on the AT-FS750/48 when the Egress Rate Limit is < 1920 kbps. Allied Telesis Inc. recommends that MAC Based Authentication and 802.
PAGE 4
AT-S105 Version 1.1.0 Software Release Notes Contacting Allied Telesis This section provides Allied Telesis contact information for technical support as well as sales or corporate information. Online Support You can request technical support online by accessing the Allied Telesis Knowledge Base: www.alliedtelesis.com/support/kb.aspx. You can use the Knowledge Base to submit questions to our technical support staff and review answers to previously asked questions.