User Guide

How to Start an AT-GS950/24 WEB Management Session

System Default Gateway - Displays the default gateway of the

switch. To change the default gateway, enter a new gateway.

When DHCP is enabled, you cannot change this parameter.

DHCP Mode - For information about setting this parameter, refer

to “DHCP Client Configuration” on page 18.

4. Click Apply.

Note

Changing the IP address ends your management session. To

resume managing the device, enter the new IP address of the switch

in the web browser’s URL field, as shown in Figure 1 on page 4.

5. After you log on to the switch with the new IP address, select Save

Configuration to Flash from the main menu on the left side of the

page to save the new IP address to memory.

Caution

If you do not select Save Configuration to Flash, the IP address

will revert to its original setting when you power cycle or reboot the

switch.