User Guide

How to Start an AT-GS950/24 WEB Management Session

Caution

This procedure causes the switch to reboot. The switch does not

forward network traffic during the reboot process. Some network

traffic may be lost.

To return the AT-S109 Management software to the default settings,

perform the following procedure:

Note

The AT-S109 Management software default values are listed in the

AT-GS950 Web User Guide.

1. From the main menu on the left side of the page, select the Tools

folder.

The Tools folder expands.

2. From the Tools folder, select Reboot.

The Reboot Page is displayed. See Figure 14 on page 32.

3. Go to the lower part of the page to the Reboot section.

4. In the Reboot Type field, use the pull-down menu to select one of the

following options:

Normal - This setting reloads all configuration parameters that are

saved in flash memory. See “Switch Reboot” on page 31 for more

information when using this selection.

Factory Default - Resets all switch parameters to the factory

default settings, including the IP address, subnet mask, and

gateway address.

Caution

This setting will cause the IP address to be reset to 192.168.1.1. You

will loose connectivity with the switch management software after

the reboot is completed and you can login again with this IP address.

Factory Default Except IP Address - Resets all switch parameters to

the factory default settings, but retains the current IP address, subnet

mask, and gateway settings saved in flash memory. If the DHCP client

is enabled, it remains enabled after this reset and assignment of the IP

address, subnet mask, and gateway settings are managed by the

DHCP server.