Installation guide

Caution

Operating Temperature

This product is designed for a maximum ambient temperature of 40

degrees C. $ 12

Caution

All Countries: Install product in accordance with local and National

Electrical Codes. $ 13

Installing the Media Converter

To install an AT-MC1x Series Media Converter, perform the following

procedure:

1. Remove all equipment from the package and store the packaging material

in a safe place.

Note

Do not remove the dust cover from the fiber optic port until you are

ready to connect the fiber optic cable. Dust contamination can adversely

impact the operating performance of the port and the media converter.

2. If you are installing the media converter on a desktop, attach the four

protective feet (provided) to each corner of the base of the unit. Do not

attach the rubber feet if you are installing the unit in an

AT-MCR12 chassis.

3. If you are installing the media converter in an AT-MCR12 chassis, refer to

the chassis’ installation guide for instructions on how to install the unit,

then proceed to Step 5.

4. Place the media converter on a level, secure surface (such as a desk or

table), leaving ample space around the unit for ventilation.

5. For an AT-MC13, AT-MC14, or AT-MC16, remove the dust cover from the

fiber optic connector and connect the cable to the fiber optic port. Verify

that the near end-node transmitter port (TX) is connected to the far end-

node receiver port (RX) and that the near end-node receiver port (RX) is

connected to the far end-node transmitter port (TX).

6. For an AT-MC15, connect the thinnet cable to the 10Base2 port.