Installation guide
Table Of Contents
- Removable Power Supply and Fan Installation Guide
- Contents
- About this Guide
- Compatible Switches
- Installing a Power Supply Unit or Fan
- Package Contents
- Connecting an AC power supply
- Connecting a PWR01 DC power supply
- Connecting a PWR05 DC power supply
- Checking LEDs
- Removing a Power Supply Unit or Fan
- Troubleshooting
- Obtaining Documentation and Resources
- Standards
- EC Declaration of Conformity
Installation Guide
5
Package Contents
Depending on the model, switches are shipped with a single supply unit (PSU),
either AC or DC. Some models also have fan-only modules (FOM), chassis fan
modules, or blanking plates.
■ The AT-8948, AT-9924Ts, x900-24XT, x900-24XT-N, and x900-24XS
switches have a PSU and a FOM installed.
■ The x900-48FE, x900-48FS, AT-9924T, and AT-9924SP switches have a PSU
and a blanking plate installed.
■ The SwitchBlade
®
x908 is shipped with dual chassis fan modules and
blanking plates, but no PSUs.
The following items are included with each factory-installed PSU. Contact your
authorised Allied Telesis distributor or reseller if any are damaged or missing.
■ one AC power cord (AC models)
■ one power cord retaining clip (AC models)
■ one warranty card
The following items are included with PSUs when purchased separately:
■ one AC power cord (AC models)
■ one power cord retaining clip (PWR01 and PWR02 AC models only)
■ one clip-on ferrite core (PWR05 only)
■ this Installation Guide
■ one warranty card
The following items are included with fans when purchased separately:
■ this Installation Guide
■ one warranty card