Installation guide

Chapter 5: Troubleshooting
110
Cannot Establish a Local (Out-of-Band) Management Session
If you are unable to establish a local (out-of-band) management session
with the switch through the terminal port on the front panel, do the
following:
 Check that the RJ-45 serial management cable is securely connected
to the serial terminal port on the switch and to the RS-232 port on the
terminal or personal computer.
 Check that the operating parameters on the terminal or the terminal
emulation program have been set correctly. The default settings for the
RJ-45 serial terminal port can be found in “Powering on a Switch with a
DC AT-PWR250 Power Supply Module” on page 95.