Installation guide

x610 Series Layer 3 Gigabit Ethernet Switches Installation Guide
61
Resiliency Link
Configurations
via Switch Ports
Two resiliency-link configurations that connect to switch ports are shown
below. Figure 31 shows the resiliency link connecting in a ring topology,
whilst Figure 32 shows the resiliency link connecting to its switch ports via
a network h
ub. In both configurations, the resiliency link connections are
made using the ResiliencyLink VLAN and attach
ing the switch ports to the
VLAN.
For more information about the stack resiliency link refer to the Stacking
Introduction and Stacking Commands chapters in t
he AlliedWare Plus
Operating System Software Reference from www.alliedtelesis.com.
Figure 31. Resiliency link Connecting to Switch Ports Over the
ResiliencyLink VLAN
Figu
re 32. Resiliency link Connecting to sWitch Ports Over the
ResiliencyLink VLAN Using a Network Hub
x610-24Ts
x610-24Ts
x610-24Ts
x610-24Ts
Stacking Links
Connecting to Switch PortsStack Resiliency Link -
ResiliencyLink VLAN
x610-24Ts
x610-24Ts
x610-24Ts
Network Hub
x610-24Ts
Stacking Links
Resiliency Links
to Switch Ports