Installation guide

AT-9006 Series Installation Guide
35
As power is applied to the switch, the Fault LED (shown in Figure
5) flashes as the switch runs a series of internal self tests. After the
switch has finished running its self tests, the Fault LED will stop
flashing and will remain OFF. Refer to the section System and
Port LEDs on page 19 for information on all of the system and
port LEDs.
Figure 5 Fault LED
6. Connect the data cables, making sure each connection has a good
valid link and that the switch is receiving packets. See Planning the
Installation on page 33 for cable specifications.
7. Go to the procedure Starting a Local Omega Management Session
on page 41 to access the Omega management interface on the
switch.
STATUS
RESET
FAULT
RPS
PWR
RS-232
TERMINAL PORT
Fault LED