Installation guide

Installation
36
Installing the Switch in a Rack
To install the switch in a standard 19-inch rack, perform the following
steps:
1. Remove all components from the shipping package and store the
packaging material in a safe location.
2. Place the unit on a level, secure surface.
3. Using a flat-head screwdriver, remove the snap-on plastic feet from
the bottom of the switch, as shown in Figure 6.
Figure 6 Removing the Feet
4. If you purchased an expansion module for the switch, install the
module by following the instructions in the section Installing an
Expansion Module on page 38.
5. Attach the rackmounting brackets to each side of the switch, using
the six flathead screws that came in the switch package, as shown in
Figure 7.
Figure 7 Attaching Rackmounting Brackets
R PORT
RS-232
TERMINAL PORT
STATUS
RESET
FAULT
POWER