Manual
Table Of Contents
- Table of Contents
- Preface
- Chapter 1
- Getting Started
- Chapter 2
- Managing the Chassis
- Chapter 3
- Managing the Modules
- Chapter 4
- Configuring the Omega Interface
- Chapter 5
- Upgrading AT-S31 Software and Configuration Files
- Appendix A
- AT-S31 Default Settings
- Appendix B
- Supported PowerBlade Modules
- Appendix C
- Technical Support Fax Order
Supported PowerBlade Modules
60
Table 3 AT-PB100 Series Media Converters
Note 1: Maximum distance can only be obtained when the UTP/STP cabling is installed and verified to
TIA/EIA 568A Commercial Building Telecommunications Cabling Standard.
Note 2: Maximum distance for 100 Mbps Optical Datalinks are dependent on the following factors:
type of optical fiber, duplex mode of both end-nodes, and maximum optical loss budget for
each of the optical fiber at the operating optical wavelength.
Model
100Base-FX Port 100Base-TX Port
Connector
Maximum
Distance
Connector
Maximum
Distance
AT-PB101 ST 2 km (1.2 mi) RJ-45
100 m
(328 ft)
AT-PB102 SC 2 km (1.2 mi) RJ-45
100 m
(328 ft)
AT-PB103/1 SC 15 km (9.3 mi) RJ-45
100 m
(328 ft)
AT-PB103/2 SC 40 km (24.8 mi) RJ-45
100 m
(328 ft)